Fitness equipment repair
We diagnose the real cause and replace worn parts on the spot when they’re on the truck: belts, decks, rollers, motors, control boards, cables, pulleys, bearings and pedals.
In-home service across the Wasatch Front
We fix treadmills, ellipticals, spin bikes, exercise bikes, rowers and weight machines where they sit, and we take them apart, move them and put them back together when they need a new home.
Pick a machine and what it’s doing. Drag to turn it.
Pick a symptom to see the parts that usually cause it and what we check on a service call.
Usually a stretched or loose running belt, a worn deck, a worn drive belt or rollers. We tension and center the belt, check the deck for wear, and replace whatever is worn out.
Book a treadmill belt repairOften the safety key or its magnet, a tripped breaker, a failed motor control board or a worn drive motor. We test power from the wall to the motor and find the actual fault.
Book a treadmill repairThe incline (lift) motor, its position sensor or the board that drives it. We recalibrate the incline and replace the motor or board when needed.
Book an incline repairDry or worn deck, roller bearings going bad, or a loose or cracked drive belt. We clean, lubricate and replace bearings, belts or rollers so it runs quietly again.
Book a noise repairError codes usually point to a speed sensor, the control board or wiring between them. Text us a photo of the code and your model number and we’ll bring the likely parts.
Book an error code repairPick a symptom to see the parts that usually cause it and what we check on a service call.
Usually dry or worn pivot bushings, worn crank bearings or loose hardware where the arms and pedal rails join. We clean, lubricate and tighten everything and replace worn bushings and bearings.
Book an elliptical repairTypically the resistance (tension) motor, its cable, the brake magnet or a slipping drive belt. We test the resistance system end to end and adjust or replace what’s failing.
Book an elliptical repairWorn arm bushings, loose pivot bolts or a worn pedal-arm bearing. We replace the worn bushings and bearings and torque everything back to spec.
Book an elliptical repairA failed power adapter, a loose console cable, the speed sensor or the console board. Send us the model and any error code so we bring the right parts.
Book an elliptical repairPick a symptom to see the parts that usually cause it and what we check on a service call.
Most often loose pedals, a loose crank arm or a worn bottom bracket bearing. We tighten or replace pedals, cranks and bearings.
Book a spin bike repairWorn brake pads on friction bikes or a misadjusted magnet on magnetic bikes. We replace pads and recalibrate the resistance so the knob feels right again.
Book a spin bike repairA worn or loose drive belt, worn flywheel bearings or something rubbing inside the belt guard. We tension or replace the belt and bearings.
Book a spin bike repairWorn adjustment pins, stripped knobs or worn seat-post sleeves. We replace pop-pins, knobs and sliders so everything stays where you set it.
Book a spin bike repairPick a symptom to see the parts that usually cause it and what we check on a service call.
The tension motor, its cable or the brake magnet near the flywheel. We test the resistance system and replace the motor, cable or magnet assembly.
Book an exercise bike repairA dead power adapter or batteries, a loose console cable or a failed speed sensor. We trace the wiring and replace the faulty part.
Book an exercise bike repairA worn drive belt, a slipping belt idler or worn flywheel bearings. We open the shroud, replace the belt or bearings and set the tension.
Book an exercise bike repairLoose or stripped pedal threads, a loose crank arm or a worn crank bearing. We replace pedals, cranks and bearings as needed.
Book an exercise bike repairPick a symptom to see the parts that usually cause it and what we check on a service call.
A stretched or broken recoil (shock) cord, or the chain or strap catching on its way in. We replace the recoil cord and the chain or strap.
Book a rower repairWorn seat rollers or a dirty, worn rail. We clean the rail and replace the rollers and their bearings so the seat glides again.
Book a rower repairDead batteries, a loose sensor cable or a failed speed sensor at the flywheel. We test the sensor and wiring and replace what’s failed.
Book a rower repairA dry or worn chain, worn flywheel bearings or a loose housing or damper. We lubricate, tighten and replace worn bearings and chains.
Book a rower repairPick a symptom to see the parts that usually cause it and what we check on a service call.
Cables wear where they bend around pulleys and at the end fittings. A frayed cable can snap under load, so stop using the machine. We replace cables with the right length and fittings.
Book a cable replacementDry or bent guide rods, a bent selector stem or worn guide bushings. We clean and lubricate the rods and straighten or replace bent parts.
Book a weight machine repairWorn pulley bearings or cracked pulleys, which also wear out the cable faster. We replace the pulleys and bearings.
Book a weight machine repairCracked upholstery and loose pad hardware. We replace or re-cover pads and tighten the seat and pad mounts.
Book a pad replacementPick a symptom to see the parts that usually cause it and what we check on a service call.
Cables wear at pulleys and end fittings. Stop using a frayed cable. We replace cables on functional trainers, crossovers and home gyms with the correct length and fittings.
Book a cable replacementWorn pulley bearings or cracked pulley wheels. We replace pulleys and bearings and check the cable for damage they caused.
Book a cable machine repairWorn carriage rollers, a bent pop-pin or a dirty track. We clean and adjust the track and replace rollers and pins.
Book a cable machine repairDry or bent guide rods or worn guide bushings. We clean, lubricate and straighten or replace them.
Book a cable machine repairPick a symptom to see the parts that usually cause it and what we check on a service call.
Usually stretched step chains, worn step axles and rollers, worn guide tracks or a slipping drive chain. We adjust chain tension and replace worn chains, rollers, axles and sprockets.
Book a stair climber repairWorn chain rollers, sprockets or drive motor bearings. We lubricate the drive and replace worn parts before they fail.
Book a stair climber repairA speed sensor, safety switch, the control board or wiring. Send us the error code and model so we bring the likely parts.
Book a stair climber repairEquipment we repair
Home and commercial cardio and strength equipment, repaired where it sits.
Folding, home and commercial treadmills: belts, decks, rollers, drive and incline motors, control boards and consoles.
See it in 3DFront- and rear-drive ellipticals and cross-trainers: squeaks, wobble, worn bearings and bushings, pedals and resistance.
See it in 3DSpin bikes and indoor cycles: brake pads, magnetic resistance, drive belts, cranks, pedals, flywheel noise and seat posts.
See it in 3DUpright, recumbent and air bikes: tension and resistance systems, consoles, speed sensors, drive belts and seats.
See it in 3DAir, magnetic and water rowers: chains and straps, recoil cords, seat rollers, dampers and performance monitors.
See it in 3DSelectorized strength machines, Smith machines, leg presses and plate-loaded equipment: cables, weight stacks, guide rods and upholstery.
See it in 3DFunctional trainers, cable crossovers and all-in-one home gyms: cable replacement, pulleys, bearings and full assembly.
See it in 3DStair climbers, steppers and other cardio machines: drive chains, step mechanisms, bearings and consoles.
See it in 3DDon’t see yours? We work on most makes. Send us the model.
Moving, disassembly & reassembly
Heavy machines don’t fit through every door. We take them apart, move them safely and put them back together exactly right, then test them before we leave.
We take the machine down only as far as it needs to go: consoles, uprights, arms or stacks, with every bolt bagged and labelled.
Wrapped, strapped and carried on the right dollies, up or down stairs and across town.
Rebuilt to spec, belts and cables tensioned, calibrated and run before we leave.
Services
From getting a new machine home to keeping it running and hauling away the old one.
We diagnose the real cause and replace worn parts on the spot when they’re on the truck: belts, decks, rollers, motors, control boards, cables, pulleys, bearings and pedals.
We take machines apart, move them up or down stairs or to a new home, rebuild them and test them. One piece or a whole gym.
Cleaning, lubrication, belt adjustment, tightening, calibration and a full wear check, so small problems don’t turn into big ones.
Bought a machine from a store, warehouse or a KSL or Marketplace seller? We pick it up, bring it inside, then assemble and test it.
Picked up a used machine? We clean it, replace worn parts and get it running right. We also refurbish machines for resellers.
We take out broken or unwanted equipment, including the old machine when we install your new one.
How it works
No surprise charges and no half-fixed machines.
Send the brand, model and what it’s doing. A photo of the serial number sticker helps.
We come to you and find the actual cause, not just the symptom. The service-call fee covers the trip and diagnosis.
You see the repair price before we start. Decide not to go ahead and you only pay the service-call fee.
Common parts are on the truck; others are ordered. Every machine is run and checked before we leave.
Commercial
An out-of-order treadmill costs you members, guests and reviews. We keep your fitness room running on a schedule, so problems get caught at a maintenance visit instead of by a resident.
Manufacturer-authorized warranty service is coming soon.
Request a walkthroughService area
We come to you, from Ogden down to Spanish Fork.
Outside these areas? Ask anyway. We travel for larger jobs and commercial accounts.
FAQ
Treadmills, ellipticals, spin bikes and indoor cycles, upright and recumbent exercise bikes, rowing machines, weight machines, cable machines, home gyms and stair climbers, for both homes and commercial facilities.
Yes. We disassemble the machine, move it, then reassemble and test it in its new spot. That includes stairs, basements, tight doorways, moves between homes and whole-gym relocations.
Most home and commercial brands, including NordicTrack, ProForm, Peloton, Bowflex, Schwinn, Sole, Horizon, Life Fitness, Hammer Strength, Precor, Matrix, Cybex, Star Trac, Technogym, StairMaster and Concept2. Tell us the make and model when you book so we can bring the right parts.
Every visit has a flat service-call fee that covers the trip and diagnosis. You get a quote before any repair work starts, parts are billed separately, and if you decide not to go ahead you only pay the service-call fee. Call or send a request for the current fee.
Yes, once you’ve bought it. Set a pickup time with the seller, and we’ll collect it, bring it into your home, set it up and test it. We don’t inspect machines for buyers before a sale.
Often, yes. Most breakdowns come down to a belt, deck, sensor or control board, which usually costs far less than a new machine. If a repair doesn’t make sense, we’ll tell you.
Yes. We set up scheduled visits for your fitness room, keep a service log for every machine, and give contract customers priority when something breaks.
Call the manufacturer first, because work by an unauthorized technician can affect your warranty. If the warranty doesn’t cover the problem, or you need delivery, assembly or moving, we can help.
Salt Lake, Utah, Davis and Weber counties, from Ogden to Spanish Fork. Ask us about locations outside the 801.
Book service
Call, text or send the form. We reply within one business day.